If you use this USB hub with other types of computer, you can use a USB cable (not included) to connect the micro-USB port (USB in) on board to the up-stream USB port on the computer. The orange LED on board works the power indicator, and will lights up when power supply is connected.Įach USB port has a dedicated white LED as activity indicator, and a dedicated electrolytic capacitor to help stabilizing the output voltage. Dear visitors, today we are proudly announcing a brand new product: MEGA4 This is a USB 3.1 hub designed for Raspberry Pi 4B, and it supports PPPS (per-port power switching) It adds 4 more USB 3.1 ports to your Raspberry Pi 4B, and the power on each port can be turned ON or OFF separately via software. The power supply can be connected to the power micro USB port, or the XH2.54 connector on board. You only need one 5V DC power supply to power them together.
This USB hub pHAT will solve the lack of USB port for the Raspberry Pi Zero computer. The 4 included pogo pins will connect the testing pads on Raspberry Pi A+/3A+, hence no soldering will be needed.Īce4U can back-power your Raspberry Pi A+/3A+, or take power from your Raspberry Pi A+/3A+ if you don’t like back-powering. USB HAT for RPi, RPi USB HAT, Raspberry Pi USB HAT, USB HUB for Raspberry Pi, 4 port USB hub for Raspberry pi, USB expansion for Raspberry pi, raspberry pi usb hub hat, usb hub shield for raspberry. The Zero Stem is a low-profile shim the means your Raspberry Pi can be plugged directly into a computer or USB hub without any additional cables or power supplies. Everyone needs more USB ports, for the mouse, keyboard, external USB ports. After attaching this USB hub to your Raspberry Pi A+/3A+, it immediately has 4 USB ports that could transfer data in USB 2.0 high-speed. here, which comes with the correct cable attached (micro-B plug, see note below).
An alternative to this is a dedicated OTG-hub, e.g. This is a 4-port USB hub for Raspberry Pi A+/3A+, and it can be attached underneath. An USB-OTG adapter on the other hand provides a Type A receptacle (this is where the hub is connected) and a micro-A plug (this goes to the Pis data port), see here. First find the Z-Wave USB device, on your Raspberry Pi you can list the USB devices using the following command: ls /dev/ttyACM If you have more than one device and you don’t know which one is the Z-Wave USB stick you can either try one at a time or unplug all other USB device and list the USB devices again.